LumaSense Technologies InfraWin 5 - Manual (Page 14)

InfraWin 5 Manual Working with the Devices/ Parameters Window 14
Figure 6: Parameters Window
Note: The free version of this software only allows you to select two measurement
sources at the same time. This can be measurements from two devices or
measurements from a single device and its internal temperature or intensity of
signal (with 2 color pyrometer).
Note: Once a device has been selected, you also have the ability to view and change
the parameters of the device while in the Parameters Tab of the Measurement
window. See Chapter 4 for more information on working with the Measurements.
Note: If multiple devices are selected, a separate tab will appear in the
Devices/Parameters window for each device allowing you to view and change
settings for the individual devices.
3.2 Working with Pyrometer Parameter Settings
All preset values for the device can be displayed and modified, if necessary, through the pyrometer
parameters of the Devices/Parameters window. Changing an existing pyrometer setting can be
accomplished by typing a value in an input box or by selecting a preset value from the list field.
Choose the correct settings for your application from the displayed options.
Note: The information and settings available in this section are based entirely upon the
features/capabilities of the connected device. For more information on device-specific
features and settings, refer to the documentation that came with the device.