LumaSense Technologies Pearl Control - Manual (Page 11)

Pearl Control Software Manual Introduction 11
3. Set the maximum number of COM ports the ‘Scan’ feature will use.
To configure the COM settings:
1. Select COM Settings from the File Menu.
2. The COM Setup screen will appear. These settings control which COM port the camera is
connected on.
Note: If no COM ports are displayed, the program was unable to find an available
port. Check your camera connection and settings.
3. Set the COM # and Baudrate and click Use Settings.
OR
Click Scan to have the software search for the camera. This may take up to a minute.
1.6.4 Connect a Camera or Core
1. Connect the RS232 cable to the camera.
COM # displays a
list of available
COM ports.
Baudrate for the
camera connection,
default is 115200.