LumaSense Technologies Pearl Control - Manual (Page 26)

Pearl Control Software Manual Using Calibrate Tab Features 26
4.2.3 Correct Image
The image should be corrected each time the integration time or gain are changed. This has the
same operation as using the menu: Shortcuts > Correct Image.
To correct the image:
1. Click Help and select Advanced from the drop down menu.
2. Enter the password: engineer
3. Click on the Calibrate Tab.
4. Click on the Signal Section.
5. Click Correct Image.
4.2.4 Baudrate
Baudrate is the speed at which the camera communicates to the Pearl Control Software, can be
adjusted to four different speeds (bits per second):
4800 bps
9600 bps
19200 bps
115200 bps
While most operations will not require the baudrate to change, this can be useful to adjust if
other electronics are used to communicate to the camera.
To adjust the baudrate:
1. Click Help and select Advanced from the drop down menu.
2. Enter the password: engineer
3. Click on the Calibrate Tab.
4. Click on the Signal Section.
5. Click the dropdown menu to select a different baudrate.