LumaSense Technologies Pearl Control - Manual (Page 36)

Pearl Control Software Manual Using Calibrate Tab Features 36
To use replacement code:
1. Click on the Calibrate Tab.
2. Click on Pixel Replacement.
3. Select the pixel to replace by using the tools described in Section 4.4.2.
4. Click the dropdown box arrow to select the desired Replacement Code.
5. Click Replace. The Pearl Control Software will replace the pixel with the code specified
in the Replacement Code box (Step 6).
Note: The spacebar can be used as a shortcut to apply the replacement.
6. Once a pixel has been replaced, the effect is only temporary unless it is saved to the
camera permanently. Click Save to Camera to save replaced pixels to the camera. This
operation will take several seconds to complete, and during this time the camera will
flicker.