Seed Hawk Raven 2012 - Manual (Page 191)

9
Manual No. 016-3001-003 179
Sectional Control Technology™ (SCT)
4. Select Apply or No-Apply.
Note:
Only one zone type can be created at a time.
5. Select an offset shift for the boundary that is in relationship to one-half the implement width.
6. Press OK. Viper draws the boundary line on the Scout map as the machine drive travels along the zone
boundary.
7. To close the boundary, press Finish.
Note:
Apply/no-apply zones do not have the auto close feature. Touch the Finish button and select the
Zone to finish at the end of the boundary.
8. To define additional apply/no-apply zones, repeat step 3 through 7 for each apply or no-apply boundary to
define.
Once a zone is created, it can be viewed on the Scout tab and on the Section Control tab. The Section
Control tab will show all finished zones as well as allow the operator to create the finished SCT apply/no-
apply map when all zones have been defined.
Note:
Any area not defined will default to an apply zone. However, if the create boundary selection has
been checked, it is important to create the outer boundary of the field as an apply zone.
If an existing field boundary has been selected for use in a SCT enabled job, the selected field
boundary will be displayed in the Map area. The operator may still define additional zones if
necessary for the job.