Seed Hawk Raven 2012 - Manual (Page 90)

Chapter 5
78 Seed Hawk® Viper Pro™ Installation & Operation Manual
6. Select the appropriate rate information file for rate conversion and press Next.
7. Repeat step 2 through step 6 as necessary to set up additional products.
8. If prescription maps have been assigned to products, proceed to the Prescription Rate Conversions and
Default Rates section below for details on using these values with product application using a prescription
map. If all products enabled will be applied using a “straight” or single rate, touch OK to complete the job set
up and begin product application.
Prescription Rate Conversions and Default Rates
1. When the product setup is complete for each enabled product , the Rate Conversion screen will be
displayed if any prescription maps have been assigned to products.
Rate Conversions may be used to calibrate the prescription map for the application. For example, a value of
‘2’ may be used to double the prescription rates on the selected prescription map.
The Rate Conversions may also be used to convert a prescription map from liters or ounces to gallons, or
gallons to ounces or liters. Press the Common Factors button to view some common rate conversion
values.
Note:
The Rate Conversion value must be greater than zero. In most applications, the conversion factor
will be left at the default setting of 1.0
2. Enter a conversion factor for each product that will be applied according to a prescription map and press
OK. Viper displays the Rx Map Default Value screen.
3. Enter a standard rate of application for the channel when no prescription information is available. The
default rate only affects areas where prescription rate information has not been entered.
Note:
Zero rate zones will not be affected by the default rate setting.
4. When the default rates values are set for each product, touch OK to complete the job set up process and
begin product application.