Adder Technology AdderTech SmartView XPro ADD0038/1 - Manual (Page 56)

SmartView XPro Installation and Use Page 56
Step 2 - Connect your computer to the SmartView XPro
Connect your computer's serial port to the SmartView XPro's serial port (see figure
2)
Step 3 - Select flash upgrade mode using option switch 2 (labelled UPGRADE)
Move option switch 2 on the back of the SmartView XPro to the ON position (down).
Step 4 - Power off the SmartView XPro
Remove both power supplies from the XPro.
Step 5 - Power on the SmartView with the UPGRADE switch ON
Attach the power adapter to the SmartView whilst the UPGRADE switch is ON. The
green USER display should now show a lower case 'u'. This indicates that the
SmartView is ready to be upgraded.