Adder Technology AdderTech SmartView XPro ADD0038/1 - Manual (Page 58)

SmartView XPro Installation and Use Page 58
Like the hex files, the first three digits represent the model number (e.g. 2X8
represents a SmartView 2XPro with 8 computer ports). The next four digits represent
the version number (e.g. V129 equals firmware version 1.29).
To upgrade the SmartView, check that the DAT file designation matches the model
that you have. In other words, if you have a SmartView 2XPro with 8 computer ports
and you want to upgrade to version 1.30 then the DAT file that you need would be
named 2X8V130.DAT. Also check that all the required files are loaded into the same
directory on your computer. From that directory run the upgrade file using the
following command line.
SVXPRO {Dat_file_name}.DAT
Where {Dat_file_name} is the name of the required DAT file
For example, if the name of the required DAT file is 4X16V129.DAT then use the
following command line:
SVXPRO 4X16V129.DAT
Follow the instructions given on the screen to perform the upgrade. When the
upgrade is complete the program will confirm that the upgrade has been successful
and then quit.
Step 7 - Switch the UPGRADE key to the OFF position and cycle the power
Switch the UPGRADE switch on the rear of the SmartView to the OFF position and
disconnect the power. When the power is re-applied the SmartView will operate
using the new firmware.