Adder Technology AdderTech SmartView XPro ADD0038/1 - Manual (Page 60)

SmartView XPro Installation and Use Page 60
Appendix A. Cable and connector
specifications
IMPORTANT NOTE
The maximum cable lengths supported vary widely between devices and
cables. It may be possible to use cables that are longer than those specified
below with certain PCs and peripherals but this cannot be guaranteed. If you
experience problems try using shorter cables.
A1. Keyboard, monitor and mouse to SmartView XPro
Cable specification:
All of the shared devices plug directly into the relevant ports at the rear of the
SmartView. If you use an AT style keyboard you will need an AT (5 pin DIN female)
to PS/2 (6 pin mini-DIN male) converter. Keyboard, monitor and mouse extension
cables can be used to increase the distance from SmartView up to 10m. Most
keyboards and mice will also operate at distances of 20 metres.
A2. AdderLink to SmartView XPro
Cable specification:
The AdderLink uses standard 4-pair unshielded twisted pair cable of the same type
that is commonly used for Ethernet and other networks. Unshielded and shielded
types may be used at distances up to 200 metres.
IMPORTANT WARNING
Do not connect the SmartView's extender ports to an Ethernet hub or other
digital network device. The signals carried on the twisted pair cable between
the SmartView and the AdderLink are ANALOGUE. Plugging the SmartView or
AdderLink into a digital network device such as a hub may damage you
devices