Triton FT5000 Installation Manual - Manual (Page 39)

3 9
E
XTENDED
C
ONFIGURATION
The illustration on right shows the
FT5000 extended. The primary purpose
for this configuration is for installation
in facilities with exterior walls having a
maximum thickness of 10 inches (254
mm). The dispensing mechanism has a
bill chute extension designed for the
elongated configuration. A protective
plate is inserted on the underside of the
cabinet sleeve for security and environ-
mental purpose.
The illustration on right shows the
FT5000 “collapsed” or Island
configuration. The cabinet sleeve is
moved back approximately 5 - 7/16"
inches (137 mm). This configuration
allows installation in facilities with
exterior walls having a maximum
thickness of 6 - 5/16" inches (160 mm).
The dispensing mechanism has a
shortened bill chute extension due to
the collapsed state of the unit.
I
SLAND
C
ONFIGURATION
Figure 12. Extended configuration.
Figure 14. Island configuration.
Figure 13. Screw holes for
Island configuration.
**Warning**
Units are shipped as specified con-
figurations and the dispensing mecha-
nism assembled with the required bill
chute extension. Changing configu-
rations require dispenser modifica-
tions and/or additional hardware.
YOU CAN NOT CHANGE
CABINETCONFIGURATIONS
WITHOUT THE REQUIRED
HARDWARE.
S
ITE
P
REPARATION
/I
NSTALLATION