Triton FT5000 Installation Manual - Manual (Page 47)

4 7
P
OWER AND
C
OMMUNICATION
Figure 2. Install snap bushing on
access hole that carries power
and phone cords.
POWER OUTLET
ACCESSIBILITY
Whether you are installing a new
outlet, or plan to use an existing
outlet to supply power to the ATM,
make sure the following require-
ments are met:
1. The outlet is located near the
cabinet.
2. The outlet is easily accessible.
3. Access to the outlet will not be
blocked once the cabinet is in-
stalled!
POWER SUPPLY CORD
SPECIFICATIONS
For European applications, the power
supply cord must conform to the fol-
lowing specifications:
1. Two-conductor with physical
earth ground.
2. IEC 320 molded connector on
one end and molded plug on the
other end.
3. Certified for country of
installation.
4. Rated minimum H05VV-F with
minimum 0.75 mm2 (except where
specific countries require 1.0
mm2) conductors.
5. Maximum length: 3 meters.