Triton FT5000 Installation Manual - Manual (Page 46)

4 6
3. Install the supplied snap bushing
into the access hole that carries the
power and phone cords.
See Figure 2 for an example that shows
the snap bushing on the access hole.
4. Plug the AC power plug into the
wall outlet.
5. Plug the phone cord into the wall
mounted modular phone jack.
Connecting AC Power and
Telephone Line
IMPORTANT: AC power for the ter-
minal should come from a dedicated
source with an isolated ground.
1. Ensure the power and phone cables
are routed through the cable clips
located in the vault cabinet.
2. Route the AC power cord and the
phone cord through either the front
right or left side access hole (as
applicable) in the security cabinet,
as shown in Figures 1a and 1b.
Figure 1a. Power and phone cords
routed through right front side
access hole.
Figure 1b. Power and phone cords
routed through left front side access
hole.
FT5000 - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
*** WARNING***
This unit may be equipped with more
than one power cord. DISCON-
NECT ALL POWER CORDS
PRIOR TO SERVICING!
**IMPORTANT**
The phone line used for the ATM
shall not be shared with any other
device!