SilentKnight VisorAlarm ARLY Interface - Manual (Page 20)

VISOR ALARM – ARLY Configuration
II - 15
Doc.DM359-I
Rev.2.0
The default values for these parameters meet the previous conditions.
2.4. CFG-PATTERN
Permits you to define a configuration pattern to be used for mIP/IPDACTs installation and register.
From the configuration point of view, a pattern number identifies a pattern.
An important configuration pattern parameter is the installer password as this is the password used to
encrypt the register request. When the VisorALARM receives this petition, it uses the pattern which
permits it to correctly decrypt the mIP/IPDACT request. The rest of the parameters are used by the
mIP/IPDACT in normal operating mode. All the parameters must be configured to ensure correct
mIP/IPDACT registration and configuration.
Syntax:
ARLY-1 Cfg>CFG-PATTERN <pattern_number>
default sets default values to an existing or a new
entry
instalator-password MIP instalator password to use this cfg
pattern
automatic-instalator-password Automatically generated MIP instalator
password to use this cfg pattern
receiver-ip Public IP address which MIP uses to send
alarms
receiver-udp-port UDP port used to exchange info
usr-password MIP console protected password
mip-password MIP encrypt password used to send alarms
receiver-password Encrypt password this eq. uses on mssg to
that MIP
keep-alive-timer MIP keep-alive timer in seconds
keep-alive-retries MIP keep-alive num of retries
keep-alive-retries-timer MIP time between keep-alive retries in
seconds
phone-length Number DTMF digits Alarm Panel dials to make
calls
alarm-tx-retries Times MIP retransmmit an alarm before abandon
callback-phone Phone number Alarm Panel dials to make a
callback
bck-receiver-ip Public IP address which MIP uses to send
alarms to the backup VisorAlarm
bck-keep-alive-timer MIP keep-alive timer in seconds for backup
VisorAlarm
bck-keep-alive-retries MIP keep-alive num of retries for backup
VisorAlarm
bck-keep-alive-retries-time MIP time between keep-alive retries in
seconds for backup VisorAlarm
local-events-zone Zone number to use in locally generated
events
mnt-ip-address Maintenance IP address
mnt-password Password for maintenance alarms
a) CFG-PATTERN n DEFAULT
Establishes the specified pattern’s default configuration. In order to fully delete a pattern, use the NO
CFG-PATTERN n DEFAULT command.
Syntax:
ARLY-1 Cfg>CFG-PATTERN n DEFAULT
n Pattern Number. The entries do not require consecutive numbers,
however the numerical order is important as the lowest number is