SilentKnight VisorAlarm ARLY Interface - Manual (Page 30)

VISOR ALARM – ARLY Configuration
II - 25
Doc.DM359-I
Rev.2.0
b) IO-CONF OUTPUT
Configures the general purpose output for signaling a specific condition in the VisorAlarm-
mIP/IPDACT system. Options given to the user are:
• Automation-software-down. Communication between the VisorAlarm and Automation
Software is not active.
• Alarm-pending. There is(are) signal(s), of any type, pending to be acknowledged by the
operator at the VisorAlarm receiver.
• System-trouble-pending. There is(are) system trouble signal(s) pending to be acknowledged by
the operator at the VisorAlarm receiver.
• Alarm-unrestored. There is(are) signal(s), of any type, pending to be restored to normal
conditions in the alarm system.
• System-trouble -unrestored. There is(are) system trouble signal(s) pending to be restored to
normal conditions in the alarm system.
Syntax:
ARLY-1 Cfg>io-conf output <condition>
automation-software-down
alarm-pending
system-trouble-pending
alarm-unrestored
system-trouble-unrestored
condition Condition to be signaled by the general purpose output:
• Automation-software-down.
• Alarm-pending.
• System-trouble-pending.
• Alarm-unrestored
• System-trouble-unrestored.
Example:
ARLY-1 Cfg>io-conf output alarm-pending
ARLY-1 Cfg>
The default configuration sets the general purpose output to indicate System-trouble-unrestored at
VisorAlarm receiver.
2.7. LIST
Permits the user to list the configured parameters.
Syntax: