Monitoring the sepi interface, Clear, List – SilentKnight VisorAlarm ARLY Interface User Manual
Page 94: Exit
VISOR ALARM – SEPI Monitoring
V - 89
Doc.DM359-I
Rev.2.0
2. Monitoring the SEPI Interface
To access the SEPI interface monitoring, user the NETWORK command and the serial line associated
to the SEPI interface from the monitoring process:
+network serial0/0
SEPI-serial0/1 Monitoring
SEPI-serial0/1+
The available commands are as follows:
SEPI-serial0/1+?
CLEAR
LIST
EXIT
ARLY-1+
2.1. CLEAR
This command deletes the interface statistics.
Syntax:
SEPI-serial0/1+clear all
2.2. LIST
This command displays the interface statistics.
Syntax:
SEPI-serial0/1+list all
Interface statistics:
---------------------
Device status................................: PRESENT
Frames sent to serial device.................: 1
Bytes sent to serial device..................: 94
Frames received from serial device...........: 0
Bytes received from serial device............: 0
2.3. EXIT
Permits you to exit the SEPI interface monitoring and return to the + prompt.
Syntax:
SEPI-serial0/1+EXIT
Example:
SEPI-serial0/1+EXIT
+