SilentKnight VisorAlarm ARLY Interface - Manual (Page 59)

VISOR ALARM – ARLY Configuration
II - 54
Doc.DM359-I
Rev.2.0
Example:
ARLY-1 Cfg>UPDATE MIP 101234 RECEIVER-PASSWORD 12FED00B3
ARLY-1 Cfg>
g) UPDATE MIP accnt KEEP-ALIVE-TIMER
Configures the time interval used by the mIP/IPDACT to check connectivity with the VisorALARM.
Each time this timer times out, a keep-alive frame is sent to notify the VisorALARM that the
connection is active and waits for its response.
Syntax:
ARLY-1 Cfg>UPDATE MIP accnt KEEP-ALIVE-TIMER time
time Time in seconds between keep-alive frames. Admits values between 0
and 90.
Example:
ARLY-1 Cfg>UPDATE MIP 101234 KEEP-ALIVE-TIMER 30
ARLY-1 Cfg>
h) UPDATE MIP accnt KEEP-ALIVE-RETRIES
Configures the number of times the mIP/IPDACT will transmit a keep-alive frame without receiving a
response from the VisorALARM. If the mIP/IPDACT, on executing the connectivity test with the
Teldat VisorALARM, does not receive a response within the “time-between-send-keep-alive-retries”
seconds, the mIP/IPDACT repeats the process of transmitting the keep-alive frame. Should there be
no response within same time interval, the mIP/IPDACT repeats the process until the number of retries
configured in the register has been completed. The connection with the Teldat VisorALARM is
considered down once the number of configured retries in this register has been executed and
subsequently the control panel can access the telephone network.
Syntax:
ARLY-1 Cfg>UPDATE MIP accnt KEEP-ALIVE-RETRIES num_times
num_times Number of times the keep-alive frames are sent when the no response
is received. Admits values between 1 and 9.
Example:
ARLY-1 Cfg>UPDATE MIP 101234 KEEP-ALIVE-TIMER 30
ARLY-1 Cfg>
i) UPDATE MIP accnt KEEP-ALIVE-RETRIES-TIMER
Configures the time interval used by the mIP/IPDACT to send keep-alive retries to notify the
VisorALARM that the connection is active.
Syntax:
ARLY-1 Cfg>UPDATE MIP accnt KEEP-ALIVE-RETRIES-TIMER time
time Time in seconds between keep-alive frames when a possible
connectivity problem is detected. Admits values between 3 and 9.