Alamo GR60 - Manual (Page 11)

SAFETY
GR60/72 02/07 Safety Section 1-5
© 2007 Alamo Group Inc.
SAFETY
Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining
this machine in good working order.
(SG-21)
Transport only at speeds where you can maintain control of the
equipment. Serious accidents and injuries can result from operating this
equipment at high speeds. Understand the Tractor and Implement and how it handles
before transporting on streets and highways. Make sure the Tractor steering and brakes
are in good condition and operate properly.
Before transporting the Tractor and Implement, determine the proper transport speeds for
you and the equipment. Make sure you abide by the following rules:
• Test the tractor at a slow speed and increase the speed slowly. Apply the Brakes
smoothly to determine the stopping characteristics of the Tractor and Implement. As
you increase the speed of the Tractor the stopping distance increases. Determine the
maximum transport speed not to exceed 20 mph (30 kph) for towing this equipment.
• Test the equipment at a slow speed in turns. Increase the speed through the turn only
after you determine that it is safe to operate at a higher speed. Use extreme care and
reduce your speed when turning sharply to prevent the tractor and implement from
turning over. Determine the maximum safe turning speed for you and this equipment
before operating on roads or uneven ground.
• Only transport the Tractor and Implement at the speeds which allow you to properly
control the equipment.
Be aware of the operating conditions. Do not operate the Tractor with weak or faulty brakes
or worn tires. When operating down a hill or on wet or rain slick roads, the braking distance
increases: use extreme care and reduce your speed. When operating in traffic always use
the Tractor’s flashing warning lights and reduce your speed. Be aware of traffic around you
and watch out for the other guy.
(SG-19)
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running. Make sure the tractor engine is off, the
transmission in park, the parking brake set, and that the key is with you before working on
the implement.
(SG-20)