Alamo GR60 - Manual (Page 82)

ASSEMBLY
GR60/72 02/07 Assembly Section 3-8
© 2007 Alamo Group Inc.
ASSEMBL
Y
Driveline Attachment - GR60 (Figure Asm-0051)
Before starting assembly, make certain that all
paint, dirt, and grease are removed from gearbox
shaft (1). To ease assembly apply a light coat of
grease to splines and assemble. Do not assemble a
driveline without a shield. Entanglement in rotating
shafts can kill.
1. Attach the slip clutch end of the driveline to the
gearbox input shaft securely. Make certain that
the slip clutch is fully onto the input shaft
splines. Tighten the locknuts (2) alternately
until they have reached the proper torque.
Refer to Torque Chart in the Maintenance
Section.
Driveline Attachment - GR72 (Figure Asm-0044)
1. Remove washer, castle nut, and cotter pin from
gearbox shaft. Install clutch yoke on shaft.
Attach yoke to clutch by inserting spacer flat
(#1) between yoke and clutch. Insert 5/16 x 3-
1/2 bolts (#2) and install locknuts (#3). Tighten
securely. Install washer and castle nut on
gearbox shaft between yoke ears. Tighten
Mounting Nut and then back off to allow
approximately .015 clearance.