3 tractor horsepower, 4 3-point hitch, 5 front end weight – Alamo GR60 User Manual

Page 88: Operation, Opera t ion

Advertising
background image

OPERATION

GR60/72 02/07

Operation Section 4-6

© 2007 Alamo Group Inc.

OPERA

T

ION

3.3 Tractor Horsepower

The power required to operate a mower is determined by the tractor PTO horsepower. For most mowing

conditions, the GR60/72 mower requires at tractor with at least 30 and 40 HP, respectively. Operating the

mower with a tractor that does not have adequate power may damage the tractor engine. Exceeding 90 HP

may cause mower damage by overpowering the unit in heavy cutting conditions.

3.4 3-Point Hitch

The tractor 3-point hitch must be rated to lift at least

1370 lbs. if attaching a GR60 and 1578 lbs. if

attaching a GR72 mower.

GR60/72 mowers can attach to tractor’s with either

a CAT I or II hitch. Refer to the tractor operator’s

manual for the category of the tractor used. If the

hitch does not conform to ASAE Cat I or II

dimensions, the mower may not fit or raise properly.

Consult an authorized dealer for possible

modification procedures to mount nonconforming

hitches.

Use the correct hitch pins for the hitch category

being used. For a Cat I hitch, 7/8” lower and 3/4”

upper diameter hitch pins are used and Cat II

hitches require 1-1/8” lower and 1” upper diameter

hitch pins.

CAT I Implement / Hitch Specification

CAT II Implement/ Hitch Specification

Width from outside to outside A-frame.... 26-7/8”

Width from outside to outside A-frame ....32-3/8”

Quick Hitch width inside lug to lug ......... 27-1/8”

Quick Hitch width inside lug to lug ..........33-5/8”

Height from bottom hitch pin to top pin ... 18”

Height from bottom hitch pin to top pin ...19”

Lower pin diameter ................................. 7/8”

Lower pin diameter .................................1-1/18”

Upper pin diameter ................................ 3/4”

Upper pin diameter .................................1”

Lynch pin diameter ................................. 15/32”

Lynch pin diameter..................................15/32”

3.5 Front End Weight

A minimum of 20% total tractor weight must be maintained on the tractor front end at all times. Front end

weight is critical to maintain steering control and to prevent the tractor from rearing up while driving. If the

front end is too light, add weight until a minimum of 20% total weight is reached on the front tires. Front

weights and weight carriers can be purchased through an authorized tractor dealership. OPS-U- 0005

Advertising
This manual is related to the following products: