See clutch maintenance), Excessively mower, Springs weak. replace springs – Alamo GR60 User Manual
Page 124: Improper adjustment. re-adjust slip clutch, Intake, Friction facings worn. replace facings, Oil on facings. replace facings, Friction facings glazed. clean with emery cloth, Shallow cavity plug. cavity in oil plug should be, Approximately 5/8
OPERATION
GR60/72 02/07
Operation Section 4-42
© 2007 Alamo Group Inc.
OPERA
T
ION
Problem
Possible Cause
Remedy
Slip Clutch Slipping
Excessive load.
Reduce ground speed and/or raise
(See Clutch Maintenance).
Excessively
Mower.
Springs weak.
Replace Springs.
Improper adjustment.
Re-adjust Slip Clutch.
Too much power for Slip Clutch.
Reduce ground speed and material
intake.
Friction Facings worn.
Replace Facings.
Oil on Facings.
Replace Facings.
Friction Facings glazed.
Clean with emery cloth.
Oil Blowing out Vent Plug
Flat bottomed Vent Plug or
Replace with proper Vent Plug,
shallow cavity Plug.
Cavity in Oil Plug should be
approximately 5/8”.
Oil level too high.
Lower oil level to Plug.
Gearbox Leaking
Damaged Oil Seal.
Replace Seal.
No Oil Seal.
Install Oil Seal.
Oil too light.
EP140.
Bent Shaft.
Replace Oil Seal and Shaft.
Oil Seal Race rough.
Replace Shaft or repair Race.
Oil Seal installed wrong.
Replace Seal.
Oil Seal not sealing in the housing.
Replace Seal or use a sealant on O.D.
of Seal.
Bearings loose.
Adjust Bearings.
Vent Plug stopped up.
Open Vent Plug.
Oil level too high.
Drain oil to proper level.
Gasket damaged.
Replace Gasket.
Bolts loose.
Tighten Bolts.
Driveline Integral Shields
Install Shields deformed.
Replace Shield.
Rattling or Not Turning Freely
Nylon Bearing worn.
Replace Nylon Bearing.