In-Situ smarTROLL Multiparameter Handheld Operators Manual - Manual (Page 19)

19
Important: Avoid touching the sensor lens and the sensing
material on the top of the cap.
5. Remove the orange plug from the pH/ORP port.
6. Remove the pH/ORP sensor from the storage bottle. Keep the bottle for future
sensor storage.
7. Use the alignment marks to properly align the pH/ORP sensor with the port
connection, and press firmly into place. Push until the sensor is completely inserted
into the port.
8. Twist the restrictor onto the probe.
9. Align the pins on the cable with the pins on the probe, then twist the outer portion of
the connector until the connection is secure.
10. Align the pins on the cable with the pins on the battery pack, then twist the outer
portion of the connector until the connection is secure.
Important: The RDO Sensor Cap and pH/ORP sensor must be
installed firmly in place to prevent water from entering the
instrument.