KYORITSU 2009R User Manual
Page 4
̶ 2 ̶
Following symbols are used on the instrument and in the instruction
manual. Attention should be paid to each symbol to ensure your
safety.
Refer to the instructions in the manual.
This symbol is marked where the user must refer to the
instruction manual so as not to cause personal injury or
instrument damage.
Indicates an instrument with double or reinforced insulation.
Indicates that this instrument can clamp on bare conductors
when measuring a voltage corresponding to the applicable
Measurement category, which is marked next to this symbol.
Indicates AC (Alternating Current).
Indicates DC (Direct Current).
Indicates AC and DC.
This instrument satisfies the marking requirement defined in
the WEEE Directive. This symbol indicates separate collection
for electrical and electronic equipment.
DANGER
●Never make measurement on a circuit above 750VAC/1000VDC.
● Do not attempt to make measurement in the presence of
flammable gasses, fumes, vapor or dust. Otherwise, the use of the
instrument may cause sparking, which can lead to an explosion.
● Never attempt to use the instrument if its surface or your hand is
wet.
● Do not exceed the maximum allowable input of any measurement
range.
● Never open the battery compartment cover when making
measurement.
● Never try to make measurement if any abnormal conditions, such
as broken Transformer jaws or case is noted.
● The instrument is to be used only in its intended applications
or conditions. Otherwise, safety functions equipped with the
instrument doesn't work, and instrument damage or serious
personal injury may be caused.