KYORITSU 6202 - Manual (Page 13)

― 11 ―
Outer dimension and weight
Outer dimension: 185(L) × 167(W) × 89(D)mm
Weight: Approx. 1kg (only the instrument body)
Symbols used on the instrument:
F Equipment protected throughout by DOUBLE INSULATION or
REINFORCED INSULATION
Caution (Refer to the accompanying instruction manual)
！
5．1 Visual inspection
Before starting a measurement, user should undertake visual checks on the
mains cord, case and that the correct type and rated fuse is fitted to the DUT.
And also there should be no evidence of damage of a nature that may impair
the electrical safety of the item.
5.2 Connection to mains power supply
5.2-1 Connection of mains cord
Set the range switch on the instrument to "VOLT" range and insert the socket
of mains cord to the instrument. Then connect the plug to the outlet of mains
power supply.
CAUTION
● Always be sure to check there is no abnormal conditions or damages on
the instrument and cords. If any evidence of abnormality found,
measurement shall be stopped immediately.
● The outlet of mains power supply must have earth terminal.
● This instrument can be only connected to the commercial power of
230V+10%-10%, 50/60Hz.
！
5. Preparation before a measurement
Fig.7