KYORITSU 2009A - Manual (Page 22)

― 20 ―
DANGER
●Never use the instrument on a circuit above 750VAC/1000VDC.
This may cause electrical shock hazard and damage to the
instrument or the circuit under test.
●Do not make measurement with the battery compartment cover
removed.
●Do not make measurement with the test leads plugged into the
instrument.
●Keep your fingers and hands behind the barrier during measurement.
①The PEAK mode is available on DCA, ACA, DCV and DCA ranges.
Set the function selector switch to the desired position.
Note：Only on DCA range, press the Zero Adjust/Reset button for
about one second to zero adjust the reading with the
transformer jaws closed.
②Press the mode selector button twice to enter from the normal mode
to the PEAK mode. "PEAK" should be shown on the display.
③Follow instructions for DCA, ACA, DCV or ACV measurement.
Note：For accurate reading, press the Zero Adjust/Reset button to reset
the reading after clamping onto the conductor or making test lead
connections to the circuit under test. Then, proceed to
measurement.
Ｖｐ
INPUT Current
Ｖｐ／ 2
Peak Hold