Revo RE8/16DVR1 - Manual (Page 40)

User’s Manual
32
Highlight the desired box under the Alarm-Out heading, and press the
button. A list of Alarm Outputs and Beep
appear. Select the Alarm Output connectors that you would like to activate whenever the DVR detects an input on the
associated alarm input. You can also set the DVR’s internal buzzer to sound.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the
Alarm-Out setup screen (Schedule tab).
Highlight the desired box under the Notify heading, and press the button. The Alarm-In Notify menu appears.
You can toggle the entire list On and Off by highlighting Notification and pressing
the
button. You can toggle the individual items On and Off by highlighting that
item and pressing the button. Highlight OK and press the button to accept your
changes.
NOTE: For the Notify action, the notify item you select should be enabled in the
Notification setup screen and the DVR should be registered in the REVO
Remote Pro (Remote Administration System).
Highlight the desired box under the PTZ heading, and press
the button. A list of PTZ presets appear. Select the preset
position for each PTZ camera, where you want PTZ cameras
to move to whenever the DVR detects an input on the
associated alarm input.
Highlight the desired box under the Spot Monitor heading,
and press the button. A list of SPOT monitors and cameras
appears. Each SPOT monitor can be associated with a camera.
The DVR will display the associated camera on the SPOT
monitor whenever it detects an input on the associated alarm
input.
Figure 44 — Alarm-In Actions 2 screen.
Motion Detection
Highlight Motion Detection in the Event menu and press the button. The Motion Detection setup screen appears.
Your DVR has built-in video motion detection. Video motion
detection can be turned On or Off for each camera.
Figure 45 — Motion Detection Settings screen.
Highlighting the box under the Sensitivity heading and pressing the button allows
you to adjust the DVR’s sensitivity to motion for Daytime and Nighttime independently.
There are five settings with 1 being the least sensitive and 5 being the most sensitive.
You can define the area of the image where you want to detect motion; e.g., a doorway. Highlight the box under the
Zone
heading, and press the button. The Motion Detection Zone screen displays.