Revo RE8/16DVR1 - Manual (Page 52)

User’s Manual
44
Live Monitoring Menu
Freeze
Selecting (Freeze) in the Live Monitoring menu will freeze the current image on the screen until you select again.
It is the same as pressing the (Play/Pause) button. Pressing any button except for the
MENU
and
PANIC
buttons
while in the Freeze mode can also exit the Freeze mode. While in the Freeze mode, the icon displays in bottom-left
corner if Freeze is selected in the Display setup screen (OSD tab).
Sequence
Selecting (Sequence) in the Live Monitoring menu causes the cameras to display sequentially. It is the same as
pressing and holding the
SEQUENCE
button for three seconds or longer. When in one of the multi-view formats,
pressing this button will cause the DVR to go through predefined screen layouts (Full Sequence). Or, the bottom, right
screen will display live cameras sequentially (Cameo Sequence). For example, if you press the
SEQUENCE
button
in the 2x2 format, the DVR changes pages as follows:
< Full Sequence >
< Cameo Sequence >
Selecting again in the Live Monitoring menu exits the Sequence mode. While in the Sequence mode, the icon
displays in bottom-left corner if Sequence is selected in the Display setup screen (OSD tab). If all the cameras in a page
are Off, or have lost video or are set to Covert (unless the user has authority to view covert cameras), that page will be
excluded from the sequence.
NOTE: The Full Sequence for the full sequence monitoring and the Cameo Sequence for the cameo sequence
monitoring should be selected in the Display setup screen (Main Monitor tab).
Camera Menu
Selecting (Camera Menu) in the Live Monitoring menu displays the following Camera Menu.
 Audio: Selecting Audio toggles audio output On and Off.
 Color Control: Selecting Color Control and choosing the camera number allows you to control brightness, contrast,
hue and saturation for each camera for the selected camera if a user who has Color Control authority logs into the
system. It is the same as pressing and holding a camera button for a few seconds.
NOTE: It is important that cameras and monitors are correctly installed and adjusted prior to making any image
adjustments using the DVR’s controls.
Any image adjustments you make will be applied to both the live video on the monitors and the recorded
video.
 Spot Monitor: Selecting Spot Monitor allows you to select the camera you want to display on a Spot monitor. Refer
to the following Spot Monitoring section for details.
NOTE: The Camera Menu also can be displayed by clicking the right mouse button on the screen while in the
live monitoring mode.
 PTZ: Selecting PTZ and choosing the camera number allows you to control the selected camera
as long as it has Pan, Tilt and Zoom capabilities. It is the same as pressing the
PTZ
button. Refer
to the following PTZ Mode section for details.
 Zoom: Selecting Zoom and choosing the camera number zooms the current image of the selected
camera on the screen. It is the same as pressing the
ZOOM
button. Selecting Zoom again in the
Camera Menu again exits the Zoom mode. Refer to the following Zoom Mode section for details.