West Control Solutions D280-1 - Manual (Page 25)

name value range description default
41 special (-2,5...115 mV scaling necessary r page36)
42 special (-25...1150 mV scaling necessary r page 36)
43 special (-25...90 mV scaling necessary r page 36)
44 special (-500...500 mV scaling necessary r page 36)
45 special (-5...5 V scaling necessary r page 36)
50 potentiometer 0...160 Ohm
51 potentiometer 0...450 Ohm
52 potentiometer 0...1600 Ohm
S.Lin
linearization only adjustable with
S.tYP: 18, 23, 24, 30, 40 ... 45
0
0 none
1 Special linearization
Editing the linearization table with BlueControl (engineering tool) is
possible. The characteristic for KTY 11-6 temperature sensors is factory-set.
Corr
measurement value correction / scaling 0
0 no correction
1 offset-correction (in CAL - level)
2 2-point-correction (in CAL - level)
3 scaling (in PArA - level)
fAI1 forcing INP (only visible with BlueControl!) 0
0 no forcing
1 forcing via interface
Lim
name value range description default
Fnc.1
Fnc.2
Fnc.3
function of limit 1 (2, 3) 1
0 switched off
1 measured value monitoring
2 measured value monitoring + storing of alarm status.
A stored limit value can be set back via error list or digital input or
è -key (® LOGI/ Err.r).
3 signal change
4 signal change + storing of alarm status.
A stored limit value can be set back via error list or digital input or
è -key (® LOGI/ Err.r).
Src.1
Src.2
Src.3
source for limit value 1 (2, 3) 0
0 process value = absolut alarm
1 control deviation Xw (processvalue - set-point) = relative alarm
2 control deviation Xw (=relative alarm) with suppression at start
and with set-point change
3 measured value INP
6 set-point
7 y (controller output)
Hour OFF..999999 operating hours (only visible with BlueControl!) OFF
Swit OFF..999999 operation cycle number (only visible with BlueControl!) OFF
Configuration level
25 Configuration Digital 280-1