West Control Solutions D280-1 - Manual (Page 26)

Out.1 und Out.2
name value range description default
O.Act
circuit direction of output OUT1 0
0 direct / open circuit principle
1 inverse / closed circuit priciple
Y.1
controller output Y1 0
0 not active
1 active
Lim.1
Lim.2
Lim.3
message limit value 1/2/3
0 not active
1 active Out.1/2/3
FAi.1
message INP error 0
0 not active
1 active
fOut forcing OUT1 (2) (only visible with BlueControl!) 0
0 no forcing
1 forcing via interface
Out.3
name value range description default
O.tYP
signaltype OUT3 0
0 relay / logic
1 0 ... 20 mA continuous
2 4 ... 20 mA continuous
3 0...10V continuous
4 2...10V continuous
5 transmitter supply
O.Act
circuit direction of output OUT3 (only visible with O.TYP=0 ) 1
0 direct / open circuit principle
1 inverse / closed circuit priciple
Y.1
controller output Y1 (only visible with O.TYP=0) 0
0 not active
1 active
Lim.1
message limit value 1 (only visible with O.TYP=0) 1
0 not active
1 active
Lim.2
Lim.3
message limit value 2/3 (only visible with O.TYP=0) 0
0 not active
1 active
FAi.1
message INP-error (only visible with O.TYP=0) 1
0 not active
1 active
Out.0 -19999...
99999
scaling of analog output for 0% (0/4mA e.g. 0/2V, only visible
with O.TYP=1..5)
0
Out.1
-19999...
99999
scaling of analog output for 100% (20mA bzw. 10V, only
visible with O.TYP=1..5)
100
Configuration level
26 Configuration Digital 280-1