Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 13)

Installation Manual
COMPLETE THE INSTALLATION
After programming, add seal caps to the front and rear screws of the index cover plate Only the front screw is shown below
Figure 18: Add seal caps on index cover plate
If the index mounting seal caps were removed, replace them with the extra caps provided in the installation kit
Figure 19: Replace seal caps on index mounting
This completes the installation of an ORION integral endpoint on an American Commercial Diaphragm and Turbine Meter
with Wire Seal Security Screw converted to seal caps
Page 13 July 2014