Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 15)

Installation Manual
Adding Additional Labels
If the utility chooses to add an additional label, follow the steps below If not, see "Install The Orion Integral Endpoint And
American Cover Plate" on page 16
Serial number label
Figure 22: Serial number label
1 With a needle nose pliers, pull the plastic cover plate down and off See Figure 23
Figure 23: Remove plastic cover
2 Place a new serial number tag above the one that is on the endpoint
Figure 24: Place new serial number tag
3 Place the cover plate back on the endpoint
Figure 25: Place cover plate on endpoint
Page 15 July 2014