Alpine TMI-M990 - Manual (Page 17)

13
- EN
Adjusting the Display Back and Forwards
The monitor opening angle can be set in 2 positions.
1
Press and hold OPEN/CLOSE / SETUP for at least 2
seconds while the display is out.
2
Press OPEN/CLOSE / SETUP or VISUAL EQ and
select SLIDE.
When you press OPEN/CLOSE / SETUP, you move
to the next item, press VISUAL EQ to move to the
previous item.
3
Press / TILT or / TILT, and select BACK or
FRONT.
The display can slide about 1 cm back and forwards.
4
When you have finished adjusting, press and hold
OPEN/CLOSE / SETUP for at least 2 seconds.
○○○○○○○○○○○○○
○○○○○○○○○○○○○○○○○○○○○○○○○○
• If the display stops during opening/closing, then press OPEN/
CLOSE / SETUP again. If it still does not move, then contact
your Alpine dealer. Do not force the display. You may damage
your TMI-M990.
• The display activates using the values stored for angle
adjustment and back and forward adjustment.
See “Adjusting the Display Back and Forwards” (this page),
and “Adjusting the Monitor Viewing Angle” (page 14).
○
○
○○○○○○○○○
Supplement See page 18 for supplementary information.