Alpine TMI-M990 - Manual (Page 59)

55
- EN
Parking Brake Lead Connection
If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc.
1 2
Vehicle Cable
Stopper
Monitor Cable
Pinch Connector
Pliers
Foot Brake Lead / Parking Brake Lead Connection
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold
separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when TMI-M990 is used
individually.
• If the switched power (ignition) lead of the TMI-M990 is connected directly to the positive (+)
post of the vehicle‘s battery, the TMI-M990 draws some current (several hundred milliamperes)
even when its switch is placed in the OFF position and the battery may be discharged.
FOOT BRAKE
PARKING BRAKE
(Yellow/Black)
TMI-M990
Monitor
Foot brake lamp
Foot brake switch Foot brake lead
Parking brake lead Parking brake switch
Battery
Chassis
Parking brake lamp
Pinch
Connector
Pinch
Connector (Yellow/Blue)
BATTERY
IGNITION
(Red)
(Yellow)
SPST SW (Optional)
FUSE (1A)
(Optional)
FUSE (7.5A)
(Optional)
TMI-M990
(Monitor)
Battery