Alpine TMI-M990 - Manual (Page 65)

61
- EN
When connecting Navigation System
TMI-M990
AV-Interface unit
2
1
• When the NVA-N751AS is connected for the Navigation System, use the RGB conversion cable
KWE-503N (Sold separately).
1 RGB Cable (Included with NVE-N852, not included with NVE-N871A)
2 RGB Input Terminal
Connect this to the RGB output terminal of the Navigation System.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car's electrical harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if
necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible.
Your Alpine dealer carries various noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for
further information.
NVE-N852A/NVE-N871A
Navigation system
(Sold Separately)