Alpine TMI-M990 - Manual (Page 19)

15
- EN
Moving the Monitor to be Flat
When you want to operate some function on the car (air conditioner, etc.) which is hidden by the
raised monitor, use this function.
1
Press and hold /FLAT for at least 2 seconds.
The monitor moves to the flat position.
2
Press and hold /FLAT again for at least 2 seconds.
The monitor returns to the previous angle.
• The monitor returns to the previous angle from being flat after 10 seconds.
• If an excessive force is added to the monitor when the monitor is flat, putting an object on
the back of the monitor for example, it may cause a malfunction.
The following operation is performed with the supplied
remote control.
Adjusting the Volume
1
Press / VOLUME or / VOLUME to adjust the volume.
Adjust the volume output to the Amplified Speaker that is connected to the
AUX Audio Output (AUX OUT 1) Terminal.
• The volume changes continuously if / VOLUME or / VOLUME is held down.
• The volume can be adjusted for each source.
When connected with an IONBUS compatible head unit:
• The volume adjustment is performed at the head unit. For details, see Operating from the
Head Unit “Adjusting the Volume”, page 47.
The following operation is performed with the supplied
remote control.
Supplement See page 19 for supplementary information.