Alpine TMI-M990 - Manual (Page 57)

53
- EN
Installation
Installing the Monitor
Installation Location
Before deciding on the mounting location,
check that opening and closing the display will
not hamper gear shifting in that position.
• Install at an angle of within 30 degrees from
the horizontal.
1
Slide the mounting sleeve into the
dashboard. Install the supplied bracket
on the monitor.
• Make sure to use the supplied screw
(M4 x 3) to install the monitor.
If you use another screw to install the
monitor, it may cause a malfunction.
Screws (M4 x 3)
(Included)
Mounting Bracket
(Included)
Dashboard
Mounting Sleeve
(Included)
TMI-M990
2
TMI-M990
Front Frame
(Included)
Bolt Stud
Metal Mounting
Strap
Screw
Hex Nut
(M5)
Ground
Lead
Chassis
Wider edge should
face down.
Reinforce the monitor unit with a metal
mounting strap (not supplied). Secure
the ground lead of the unit to a clean
metal spot using a screw (
★) already
attached to the vehicle's chassis.
• For the screw marked
★★, use an
appropriate screw for the chosen
mounting location.
Continued