Alpine TMI-M990 - Manual (Page 33)

29
- EN
Switching the Function of the Remote Sensor
The remote sensors of the external unit (monitor, etc.), can be selected for Remote control operation
from the external unit.
Setting item: REM.CON IN
Setting content: FRONT, REAR-1, REAR-2
FRONT:
The remote control sensor on the main unit is
enabled. Remote control operation from any
external monitor is disabled.
REAR-1* 4 : The remote sensor of the external monitor
connected to AUX OUT1 is enabled. Remote
control operation of the source selected for AUX
OUT1 only, is possible.
REAR-2: The remote sensor of the external monitor
connected to AUX OUT2 is enabled. Remote
control operation of the source selected for AUX
OUT2 only, is possible.
* 4 Can be set only when an IONBUS compatible head unit is connected.
• When set to REAR-1/2, remote control operation cannot be
performed on the FRONT (TMI-M990). In this case, perform
operation with the buttons of the TMI-M990 main unit.