Aga Ranges Pro+ Dual Fuel U110054 - Manual (Page 21)

19
ArtNo.311-0013 Burner layout
A
B
C
D
E
ArtNo.311-0014 Wok burner details
A
B
C
D
E
ArtNo.311-0015 Burner alignment
‘D’
ArtNo.311-0016 Fitting the burner inner head
A
B
Essential Information
Before thorough cleaning, turn off the circuit breaker. Allow
the range to cool.
After cleaning, remember to switch on the circuit breaker and
reset the clock before re-using the range.
Never use paint solvents, caustic cleaners, biological
powders, bleach, chlorine based bleach cleaners, coarse
abrasives or salt. Do not mix different cleaning products –
they may react together with hazardous results.
Daily Care
Cleaning the range is not a welcomed chore, but it has to be
done to maintain efficiency and appearance. Remember it
is better to wipe up any spills as they occur, this will prevent
them burning on and becoming more difficult to remove
later.
 Make sure the flow of combustion and ventilation air
to the range is unobstructed – for example by build-
up of fats or grease.
If the flame is distorted, check that the burner head is
correctly placed over the burner base.
If the flame burns with a long white tip you should call for
service.
Cleaning for Spills
For spills and boil-overs that occur while cooking, as soon as
possible turn off the burner and allow it to cool. Do not clean
until the area is completely cooled down. Wipe up spills as
soon as possible.
Do not allow surplus water to seep into the range.
Cooktop Burners
The Single Ring Burners
When refitting the burner head, make sure that the notch
lines up with the electrode or hole in the base. Check that the
burner head is level and that the cap is fitted centrally on the
burner head (Fig.6-1).
The Wok Burner
The wok burner can be taken apart for cleaning (Fig.6-2).
When reassembling the burner, turn over the large base ring
and find the ‘D’ shaped area (Fig.6-3).
Turn the head until the ‘D’ matches the one on the burner
base. Turn the head over and place it on the burner base.
To fit the small inner burner, find the larger electrode notch in
the burner rim. Line this up with the white ignition electrode
and place the inner burner on the large base ring (Fig.6-4).
Now fit the two trim rings, making sure that they are sitting
down properly.
6. Cleaning Your Range
Fig.6-2
Fig.6-3
Fig.6-1
A - cap, B - head, C - notch, D - base, E - electrode
A - inner burner cap, B - outer burner ring, C - inner burner head,
D - outer burner head, E - wok burner base
A - electrode notch, B - ignition electrode
Fig.6-4