Aga Ranges Pro+ Dual Fuel U110054 - Manual (Page 31)

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
29
ArtNo.280-0034 - Anti-Tip mounted to wall
Fig.7-14
Fig.7-15
ArtNo.280-0032 - Assembling the Anti-tip bracket
2
1 3
3
A
ArtNo.011-0020 - Positioning anti-tip bracket
Range in normal
working position
A
Floor
Fig.7-11
ArtNo.280-0033 - Anti-Tip fixed to floor
Fig.7-12 Fig.7-13
Fig.7-10
Anti-Tip Device

WARNING!
The range MUST be secured by the anti-tip bracket
supplied. Unless properly installed, the range could
be tipped by leaning on the door and injury might
result from spilled hot liquids or from the range
itself.
Note: The range must be set to the correct height and leveled
before the anti-tip bracket is installed.
Kit Contents:
1.
Anti-tip bracket base 1
2. Anti-tip bracket extension 1
3. M5 screw 2
Assemble the anti-tip bracket base and anti-tip bracket
extension as shown using M5 screws (Fig.7-10).
Dimension ‘A’ should be set to give a clearance of about ¼”
(0.6 cm) above the rear channel of the range base (Fig.7-11).
The assembled bracket should be firmly secured to the
floor to give a minimum engagement of 2’’ (5 cm) in the
rear channel of the range base. If the range is mounted on a
protective sheet make sure the bracket base is firmly attached
to the floor not just the sheet (Fig.7-12).
Wall Attachment
When floor attachment is impractical you may attach the
anti-tip bracket base securely to a solid wall or wall stud
(Fig.7-13).
For both floor and wall attachment it is essential to use the
appropriate fixing screws and to ensure that the anti-tip
bracket is firmly attached.
Side Panel Extension kit
Two side extension panels are supplied with the range. These
can be installed where the side of the range is exposed,
preferably during the installation of the appliance.
Procedure
1.
Loosen the 2 screws in the rear edge of the range side
panel.
2. Using the cut-outs, locate the side extension onto the
protruding screw heads (Fig.7-14).
3. Push the side extension up to so that the tab in the
bottom of the flue extension fits into the slot at the top
(Fig.7-15).
4. Hold the side extension in place and tighten the screws
to secure.