Aga Ranges Pro+ Dual Fuel U110054 - Manual (Page 23)

21
To remove and refit the telescopic rack and runners
Slide the rack out on the runners. While holding one of the
runners securely, carefully lift the rear of the rack upwards:
the rack will spring clear of the central restraining tab. Repeat
for the opposite side of the rack.
Note: To aid the removal of the shelf you can insert a suitable
flat tool through the opening in the side of the runners and
lever the rack clear (Fig.6-8).
Tilt the front of the rack downwards and then lift clear of the
runners (Fig.6-9).
Refit in the reverse order, making sure to push the rack down
onto the runner arms.
To remove and refit the ladder rack supports
Lift the ladder support hooks out of the two locating holes in
the oven side (or divider) before lifting the support clear of
the bottom ladder restraint.
Refit by inserting the bottom of the ladder into the restraint
before fitting the hooks through the locating holes.
Before using the self-clean function
Pre-clean any areas that are not reached by the self-clean
cycle, such as the outer edges of the oven door. Wipe up any
excess fat or liquids.
Before operating the self clean cycle, use hot water and
detergent or a paste of water and baking soda to remove any
difficult spots. Rinse off all residue with vinegar water. This
will prevent this soil from being baked on by the high heat of
the self-cleaning cycle.
Self-Clean Operation
Set the oven function control to self-clean (Fig.6-10). The
timer display will now show a ‘P’ (Fig.6-11).
Press the [D] button once (Fig.6-12) to set the default
cleaning time (3 hours). To adjust the cleaning cycle duration,
hold down the [D] button and press either the [–] or [+]
buttons and set the time as required; see Table 6-1.
Note that the maximum time for the self-cleaning operation
is 4 hours.
The cooling fan will switch to high speed and as soon as a
certain temperature is reached the oven door will lock as
indicated by the illuminated interlock neon (Fig.6-13).
Note: Because of the high temperatures generated during
the self-cleaning, the door will remain locked for some
time after the cleaning cycle has finished. When the oven
temperature has fallen sufficiently the interlock neon will go
out and the door will unlock.
 WARNING! The oven will still be hot!
When the door has unlocked turn the oven function control
back to OFF.
When the door has unlocked and the oven has cooled, use a
damp cloth the clean the debris and ash.
ArtNo.272-0007
Prof+ pyro US - MF oven -
Self clean setting
OFF
Fig.6-10
ArtNo.302-0013 -
6BC Self clean 1
Fig.6-11
ArtNo.302-0014 -
6BC Self clean 2
Fig.6-12
ArtNo.272-0008
Prof+ pyro US - MF oven -
Self clean light on
OFF
Fig.6-13
Hours Soiling
2 hours Normal clean
3 hours Heavy soiling
4 hours Very heavy soiling
Table 6-1