Aga Ranges Pro+ Dual Fuel U110054 - Manual (Page 30)

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
28
Completing the Move
Grip under the fascia panel and lift the front of the range
slightly. Carefully position the range close to its final position,
leaving just enough space to get behind it (Fig.7-8).

DO NOT use the door handles or control knobs to
maneuver the range.
IMPORTANT: Remove all tape and packaging. Make sure
the burner heads are properly seated and level. Take the
accessory pack out of the oven. Check to be sure that no
range parts have come loose during shipping.
Installing the Flue Grille
The flue grille is packed separately. Locate the grille onto the
flue and secure to the cooktop with the 4 screws supplied
(Fig.7-9).
Leveling
It is recommended that you use a spirit level on a rack in the
oven to check for level.
Place the range in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the range or the units.
The rollers can be adjusted to level the range. To adjust the
height of the rear of the range, use the leveling tool supplied
to turn the adjusting nuts at the front bottom corners of the
range.
The front feet and rear rollers can be adjusted to level the
range. To adjust the height of the rear of the range use the
leveling tool supplied to turn the adjusting nuts at the front
bottom corners of the range. To set the front feet turn the
bases to raise or lower.
Leave the leveling tool in the storage drawer, so that the
customer can use it if they wish to move the range.
Fig.7-9
ArtNo.010-0009 Pushing the cooker
Fig.7-8