Aga Ranges Pro+ Dual Fuel U110054 - Manual (Page 22)

20
Main Top
Lift away pots or pans from the main top. Remove the grates
from the spillage area and carefully place in a sink of warm
soapy water. Wipe loose debris from the main top. For best
results use a liquid detergent cleaner. Rinse with cold water
and thoroughly dry with a clean, soft cloth. Ensure all parts
are dry before repositioning.
 Avoid using any abrasive cleaners including cream
cleaners on brushed stainless steel surfaces.
 Never use caustic or abrasive cleaners as these will
damage the surface.
Control Panel and Oven Doors
The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
Removing the oven door outer panel
The outer door panel can be removed so that the inside of
the glass can be cleaned. Undo the 4 screws (2 each side)
in the door (Fig.6-5). Open the door slightly and, using the
handle, carefully lift the door outer upwards.
Refit in reverse.
Self-Clean Oven
 WARNING!
Remove all cookware, racks, and the rack supports
from the oven before using the self-clean function. If
the racks and supports are left in the oven they will
discolor and become rough.
 WARNING!
Remove the divider before using the self-clean
function. See page 10, ‘Removing the divider’.
 DO NOT clean the door gasket: the door gasket is
essential for a good seal. Care should be taken not to
rub, damage or move the gasket.
 DO NOT use oven cleaners: no commercial oven
cleaner or oven liner protective coating of any kind
should be used in or around any part of the oven.
 Clean only part listed in this User Guide.
 DO NOT use the oven light while in self-cleaning mode.
To remove and refit the racks
The rack has a small kink on either side. To remove the rack,
line these up with the stops in the rack support (Fig.6-6). Lift
the rack upwards so that it will pass over the rack stop and
then pull it forwards (Fig.6-7).
Refit in the reverse order, making sure to push it fully back.
Fig.6-6
Fig.6-7
Fig.6-8 Fig.6-9
ArtNo.272-0015 - 90DF - Pro+ - Removing the outer door panel
Fig.6-5