Brother MFC-9120CN - Manual (Page 160)

144
No Response/Busy The number you dialed does not
answer or is busy. Verify the number and try again.
No Toner The toner cartridge or the drum
unit and toner cartridge assembly
is not installed properly. Re-install the toner cartridge or the drum unit
that is indicated on the LCD.
No Waste Toner The waste toner box is not
installed properly. Re-install the waste toner box. (See
Replacing the waste toner box on page 182.)
Out of Memory The machine’s memory is full. Fax sending or copy operation in
progress
Do one of the following:
„ Press Black Start or Color Start to send
or copy the scanned pages.
„ Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
„ Clear the data from the memory. (See
Out of memory message on page 45 or
page 92.)
Print operation in process
Do one of the following:
„ Reduce print resolution. (See Advanced
tab in the Software User’s Guide on the
CD
- ROM.)
„ Clear the faxes from the memory. (See
Out of memory message on page 92.)
Print Unable XX The machine has a mechanical
problem. Do one of the following:
„ Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for
approximately 60 hours without losing
faxes stored in the memory. See
Transferring your faxes or Fax Journal
report on page 147.)
„ If the problem continues, call Brother
Customer Service.
Print Unable 1A One of the issues that can cause
this error is that condensation
may form inside the machine after
a room temperature change. Turn the power switch off and fully open the
top cover. Leave the machine off and open
for 30 minutes to remove any condensation
from inside the machine, then close the top
cover and turn it on again. If this does not
clear the error, call Brother Customer
Service.
Protected Device
(MFC-9320CW only)
The protect switch of the USB
Flash memory drive is on. Turn off the protect switch of the USB Flash
memory drive.
Error Message Cause Action