Canon EOS C500 - Manual (Page 107)

107
Special Recording Modes
Configuring Frame Recording Mode
1 Open the [Rec Frames] submenu.
[ 4K/2K/MXF Setup] > [Frame Rec] > [Rec Frames]
2 Select the desired number of frames and then press SET.
Number of Frames Recorded
Activating Frame Recording Mode and Recording
1 Open the [Special Rec] submenu.
[ 4K/2K/MXF Setup] > [Special Rec]
2 Select [Frame Rec] and then press SET.
• [FRM STBY`] (during 4K and 2K modes) or [FRM STBY] (during
MXF mode) appears at the top of the screen (with [FRM] flashing).
3 Press the START/STOP button to begin recording.
• The set number of frames are recorded automatically.
• The tally lamp illuminates.
• [FRM] changes to [Ü FRM].
• Repeat until you finish recording.
4 Open the [Special Rec] submenu.
[ 4K/2K/MXF Setup] > [Special Rec]
5 Select [Off] and then press SET.
• Frame recording mode ends and all of the recorded frames are joined together into one clip.
• [STBY`] (during 4K and 2K modes) or [STBY] (during MXF mode) appears at the top of the screen.
• The tally lamp goes out.
NOTES
• You can use only one special recording mode at a time.
• While recording, you cannot change the number of frames.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• Frame recording mode will be deactivated if the special recording mode is changed or turned off. It will be
deactivated also if you change the video configuration.
• During this special recording mode, the running mode of the time code (A 84) can be set to [Rec Run] or
[Regen.]*. The time code advances by the number of frames recorded. If the running mode of the time code
(A 84) is set to [Free Run] or the time code is input from an external source, the running mode will switch to
[Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will
return to its previous setting.
• During special recording mode, the time code signal will not be output from the MON. terminals, TIME CODE terminal
or HD/SD SDI terminal. During 4K and 2K modes, the time code signal will be output from the 3G-SDI terminals.
* During MXF mode only.
System priority Frame rate Frames recorded
4K
Any
1, 3, 6, 9 2K
MXF
59.94i, 29.97P, 23.98P, 24.00P
59.94P, 50.00i, 50.00P, 25.00P 2, 6, 12
[ 4K/2K/MXF Setup]
[ Frame Rec]
[Rec Frames]
[1]
[ 4K/2K/MXF Setup]
[ Special Rec]
[Off]
COP
Y