Canon EOS C500 - Manual (Page 64)

Video Configuration: Type of Recording, Resolution and Frame Rate
64
NOTES
• If you set an assignable button to [Resize MXF Output] (A 111), you can press the button to switch the
resizing method.
• During 4K and 2K modes, the picture output from the 3G-SDI terminals and the picture recorded on a CF card
will differ in image quality due to differences in the signal processing algorithm.
• Because the camera uses a simple resize conversion process vertically, diagonal lines may appear jagged.
Selecting the Video Configuration for MXF Mode
To set the video configuration, select the system frequency, system priority, bit rate and resolution, and frame
rate, as necessary. For a summary of the video configuration, refer to the table following the procedures below.
Selecting the System Priority
1 Open the [System Priority] submenu.
[ 4K/2K/MXF Setup] > [System Priority]
2 Select [MXF] and then press SET.
• The camera will restart in MXF mode.
Selecting the System Frequency
1 Open the [System Frequency] submenu.
[ 4K/2K/MXF Setup] > [System Frequency]
2 Select a desired option and then press SET.
• The camera will restart in the selected mode.
Selecting the Bit Rate and Resolution
1 Open the [Bit Rate/Resolution] submenu to set the bit rate and
resolution.
[ 4K/2K/MXF Setup] > [MXF] > [Bit Rate/Resolution]
2 Select the desired option and then press SET.
• The selected bit rate and resolution will appear on the upper right of
the screen.
Operating modes:
[ 4K/2K/MXF Setup]
[System Priority]
[4K]
* Depending on the country/region
of purchase.
[ 4K/2K/MXF Setup]
[System Frequency]
[59.94 Hz] or [50.00 Hz]*
[ 4K/2K/MXF Setup]
[MXF]
[Bit Rate/Resolution]
[50 Mbps 1920x1080]
COP
Y