Alliance Laundry Systems Stacked Drying Tumbler - Manual (Page 33)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 31 M412060
Operating Instructions
The following steps outline the procedure for
operating the tumbler through a complete drying
cycle.
IMPORTANT: DO NOT TUMBLE fiberglass
curtains and draperies unless the label says it can
be done. If they are dried, wipe out the cylinder
with a damp cloth to remove particles of fiberglass.
Always follow the fabric care instructions supplied by
the garment manufacturer.
NOTE: Electrical power to the tumbler must be on.
The AVAILABLE light will be lit. Refer to Figure
14.
1. Energize the electrical circuit to the tumbler at
the disconnect switch or the circuit breaker.
2. Open the lint drawer and check for any
accumulated lint on lint screen. Close drawer
tightly against tumbler front panel and lock
drawer securely.
IMPORTANT: Failure to tightly close lint drawer
will result in the tumbler not starting.
3. Open the loading door and load the cylinder with
laundry. The unit is designed for a 30 pound
cotton load (dry maximum load). DO NOT
overload! Overloading will result in excessive
drying time, wrinkled laundry and wear to
cylinder bearings or rollers.
4. Refer to Section IV of the Electronic Control
manual for further instructions on how to operate
the stacked tumbler. The Electronic Control
manual is supplied with the tumbler.
To reduce the risk of fire:
• DO NOT DRY articles containing foam
rubber or similarly textured rubberlike
materials.
• DO NOT DRY plastics, anything
containing wax or chemicals such as
mops and cleaning cloths, or anything
dry-cleaned at home with a dry-cleaning
solvent.
• DO NOT TUMBLE fiberglass curtains and
draperies unless the label says it can be
done. If they are dried, wipe out the
cylinder with a damp cloth to remove
particles of fiberglass.
W076
WARNING
To reduce the risk of serious injury, allow
cylinder to stop before cleaning lint screen.
W412
WARNING