Ampro Corporation COM 830 - Manual (Page 71)

Chapter 4 BIOS Setup Description
COM 830 Reference Manual 65
SIO Winbond W83627 Configuration
Feature Options Description
Floppy Controller Disabled
Enabled Enable / Disable the W83627 floppy controller.
Floppy A Disabled
360 KB 5¼”
1.2 MB 5¼”
720 KB 3 ½”
1.44 MB 3 ½”
2.88 MB 3 ½” Select the floppy drive A type.
Serial Port 1/2
Configuration
Disabled
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Specifies the I/O base address and IRQ of serial
port 1/2.
Serial Port 2 Mode Normal
IrDA
ASK IR Specifies the mode for serial port 2.
IR Duplex Mode Full Duplex
Half Duplex
Select IRDA full or half duplex function.
IR I/O Pin Select SINB/SOUTB
IRRX/RTX
Select receiver and transmit pins for IRDA mode.
Parallel Port Address Disabled
378
278
3BC
Specifies the I/O base address used by the parallel
port.
Parallel Port Mode Normal
Bi-directional
ECP
EPP
ECP&EPP
Specifies the parallel port mode.
EPP Version 1.9
1.7
Specifies the EPP version.
Parallel Port DMA DMA0
DMA1
DMA3 Specifies the DMA channel for parallel port in ECP
mode.
Parallel Port IRQ IRQ5
IRQ7 Specifies the interrupt for the parallel port.
NOTE This setup menu is only available if an external Winbond W83627 Super I/O has
been implemented on the carrier board.