AMX NetLinx Master-Ethernet Card/Module NXC-ME260 - Manual (Page 30)

Communication and Firmware Update
24 NXC-ME260 NetLinx Master-Ethernet Card/Module
Changing the device address on the Modero panel
The device address on a Modero touch panel can not be changed from the Device Addressing
dialog. The correct procedure to change a device address is:
1. Press and hold the grey Front Setup Access button (below the LCD on most panels) for 3
seconds to access the Setup page.
2. Press the Protected Setup button to access the Protected Setup page.
3. Use the on-screen keyboard to enter the default password of 1988.
4. Press the blue Device Number field (this opens a Device Number keypad).
5. Enter the new Device Address value.
6. Click the Done button to close the Device Addressing dialog.
7. Press the on-screen Reboot button to reboot the panel.
8. Right-click the associated System number (from the OnLine Tree tab of the Workspace
window) and select Refresh System to establish a new connection to the specified Master and
refresh the System list with devices on that system.
Recommended NetLinx Device numbers
If the Master does not appear in the Workspace window, make sure that the Master’s
System Number (from within the Device Addressing tab) is correctly assigned. If
there is a problem, use a system value of zero (0) on the Master.
• 1 - 255 • Axcess Devices use Axcess standards
• 301 - 3072 • NetLinx CardFrames start at frame number 25 - (frame# * 12) + Card #
• 5001 - 5999 • ICSNet NetLinx devices: NXI, NXM-COM2, NXM-IRS4, etc.
• 6001 - 6999 • ICSNet Landmark devices: PLH-VS8, PLH-AS16, PLB-AS16
• 7001 - 7999 • InConcert Devices
• 8001 - 8999 • PCLink Device: PCLink devices are PC programs
• 10000 - 31999 • ICSNet Panels: DMS, IMS, and future panels
• 33001 - 36863 • Virtual devices: these start at 33001
• 32001 - 32767 • Dynamic devices: the actual range used by Master
• 32768 - 36863 • Virtual devices: the actual range used by Master