AMD SimNow Simulator 4.4.5 - Manual (Page 251)

AMD Confidential
User Manual November 21
st
, 2008
Appendix A 239
GetConfig Displays the current AMD-8111 configuration.
A.7.15 EHC
1 simnow> ehc.usage
Automation Command Description
log (enable | disable) {mp}
Enables or disables Memory (m) and PCI Configuration
(p) logging.
A.7.16 Journal
1 simnow> journal.usage
Automation Command Description
GetParam
Returns „Super Block Size‟, „Index Block Size‟, „Index
Levels‟, „Disk Block Size‟ and „Maximum Disk Size‟.
SetParam <Super Block Size>
<Index Block Size> <Index
Levels> [ <Disk Block Size> ]
Sets journal parameters.
A.7.17 CPU
1 simnow> cpu.usage
Automation Command Description
LoadAnalyzer <analyzer_file>
[<args>]
Loads the analyzer „analyzer_file‟ with specified
arguments „args‟).
ShowAnalyzers Shows all loaded analyzers.
EnableAnalyzer <num> <0|1> Enables (1) or disables (0) analyzer specified by „num‟.
UnloadAnalyzer <num>
Unloads analyzer specified by „num‟.
MCAFault <bank>
<GenerateMCAFault(0|1)> <Status
Reg> <Address Reg> Causes a generic MCA fault if GenerateMCAFault is
true (1) at specified Bank, AddressReg and status.
ProductFile <FileName>
Use product file to set fuses and configure CPU and
Northbridge.
CodeGen <command> <args>
Sets or disables and enables code generator settings and
options. Command must be one of the commands shown
in Table 15-13. Args depends on the command
parameter, see Table 15-13.
DumpProfile [<blocks-to-dump>]
This command is limited to showing a profile of blocks,
without symbols, based on the current epoch. For more
information please refer to Section A.7.17.1, “Profiling
in SimNow”.
A.7.17.1 Profiling in SimNow™ Technology
Here is an example use of the profiling command and its output: