AMD SimNow Simulator 4.4.5 - Manual (Page 256)

AMD Confidential
User Manual November 21
st
, 2008
244 Appendix A
Automation Command Description
InitValStatus
Displays information if the initializer is used and if the
memory initialization is activated.
DisableCache < 0 | 1 >
Sets memory region to cacheable (0) or non-cacheable
(1).
GetCacheDisabled Returns true if non-cacheable otherwise it returns false.
GetConfig Displays Memory configuration information.
FlashMode < 0 | 1 >
Enables (1) or disables (0) this device to be used as a
flash ROM.
FlashUpdateFile < 0 | 1 >
Enables (1) or disbales (0) writes to the flash ROM to
update the ROM image.
ncHTMode < 0 | 1 >
Enables (1) or disables (0) decoding of HyperTransport
messages.
ForceInitFile <filename>
The ForceInitFile command allows the user to change
the BIOS ROM path once the simulation has already
started. This is legitimate only when the new BIOS
ROM is a byte-for-byte copy of the initial BIOS ROM
that simulation began with (i.e., same file, different
path).
GetCommandSequence
Prints which of the two command sequences the flash
device is programmed to.
CommandSequence < 0 | 1 >
0-SST, 1-ATMEL. Allows to set the command sequence
to SST or ATMEL.
GetFlashMode
Tells you if the device is configured to act as a flash
memory.
FlashMode < 0 | 1 >
Allows the user to set the memory device as flash
memory.
A.7.23 Raid
1 simnow> raid.usage
Automation Command Description
Noise [ {enable|disable} ] Enable to print debug messages; otherwise disable.
RomImage <File name>
Allows a boot ROM image to be supported - at the
moment the emulation does not work with any known
ROM images.
SetVolume <Vol #> <Image file> [
<Journal file> ] This was the original way to setup the image and journal
files - rather than having two separate commands.
DeleteVolume <Vol #>
Undoes the Image or Journal commands and puts the
volume back in an unintialized state.
Sync
This command flushes the in-memory caches out to the
files.
Type {5304|5312}
This was supposed to allow support for both the 5304
(default) and 5312 cards - the 5312 support is not well
tested.
Image <Vol #> <Image file>
Creates a volume for the give disk image (For e.g.,
raid.image 0 i:\c0d0.img).
GetImage <Vol #> Displays the disk image for the given volume.