AMD SimNow Simulator 4.4.5 - Manual (Page 33)

AMD Confidential
User Manual November 21
st
, 2008
Chapter 3: Graphical User Interface 21
IOfpdis: Mixed
MEM: Disabled
MEMfpdis: Mixed
GETMEMPTR: Disabled
1 simnow> shell.GetLogIO "-> Machine #1"
PCI: Disabled
IO: Disabled
IOfpdis: Mixed
MEM: Disabled
MEMfpdis: Mixed
GETMEMPTR: Disabled
3.3.5 Device Group Examples
Device groups can be a powerful building block for SimNow users. These next examples
should help give further understanding about device groups, and demonstrate some
practical uses.
3.3.5.1 Example: 1GB DDR2 memory
When you instantiate a “Dimm Bank” known device into a created device, you get its
default state of 8 empty dimm‟s with no configuration. You can then configure the
“Dimm Bank”, such as by opening the device‟s GUI configuration properties to specify
general options (such as max number of dimm‟s), and to configure each dimm (such as
by importing an SPD). You could configure it, for example, to emulate a dimm bank with
2 DDR2 dimm‟s (1GB each).
Device groups offer us a potentially simpler alternative - for the user to instantiate a
preconfigured device group. For example, we could have a device group “Dimm DDR2
1GBx2”, which has (inside it) only one child and default archive data (state) for that
child. The figure below shows that the (theoretical) known device “Dimm DDR2 1GBx2”
has inside it a single child device “Dimm Bank #0” that is configured with two dimm‟s
(type DDR2, 1GB each).
Figure 3-11: Example DIMM Device Group
When the user instantiates this (theoretical) known device “Dimm DDR2 1GBx2” as a
created device, we get a created device “Dimm DDR2 1GBx2 #0” with a child device
“Dimm Bank #0” that is already configured (as DDR2, 2 dimm, 1GB each). Our resulting
main device GUI would look like this:
Configured as DDR2,
2 dimm (1GB each)